turning off error messages and resetting flow time

November 24, 2003, 08:58

I have a couple of questions:

Is there a way to turn off the error messages whilst fluent is iterating? i am particularly interesed in turning off the report of reversed flow.

is there a way to reset the flow time during an unsteady calculation? I thought it could be done using the TUI but I cant find the correct command

November 24, 2003, 09:35

solve/set/flow-warnings

enable flow warning messages? [yes] no

The above will switch off the reverse flow warning messages.

(rpsetvar 'flow-time 0.0)

Will reset the time to 0 sec.

November 24, 2003, 08:58	turning off error messages and resetting flow time	#1
Phil Guest Posts: n/a	I have a couple of questions: Is there a way to turn off the error messages whilst fluent is iterating? i am particularly interesed in turning off the report of reversed flow. is there a way to reset the flow time during an unsteady calculation? I thought it could be done using the TUI but I cant find the correct command

November 24, 2003, 09:35	Re: turning off error messages and resetting flow	#2
Guest Guest Posts: n/a	solve/set/flow-warnings enable flow warning messages? [yes] no The above will switch off the reverse flow warning messages. (rpsetvar 'flow-time 0.0) Will reset the time to 0 sec.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
TimeVaryingMappedFixedValue	irishdave	OpenFOAM Running, Solving & CFD	23	December 19, 2012 10:13
TimeVaryingMappedFixedValue for Direct Numerical Simulation inlet	johndeas	OpenFOAM	4	September 26, 2011 16:55
resetting flow timer	ssn	FLUENT	0	January 2, 2008 13:09
resetting time to 0	K. Kevala	FLUENT	1	March 3, 2004 04:46