CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > FLUENT

Influence of Y+ value

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   February 6, 2004, 08:03
Default Influence of Y+ value
  #1
xiang
Guest
 
Posts: n/a
I am applying Standard wall function in my simulation. After the first try, I found Y+ values in some regions were out of the range of 30-60. Then I adapted the near wall grid with Y+ adaption (min. 30 and max. 60). The cell number increased by around 3000 after adaptation. Then I iterated again until convergence was obtained. But when I compared the velocity distribution between these two runs, it showed only negligible difference. Is this possible or I am doing anything wrong? Thanks for all your opions.
  Reply With Quote

Old   February 6, 2004, 14:02
Default Re: Influence of Y+ value
  #2
Melih GULEREN
Guest
 
Posts: n/a
Did you look near-wall or mean flow profile? I think, if you look near-wall by a log-scale, you will see the difference...

Regards
  Reply With Quote

Old   February 6, 2004, 20:27
Default Re: Influence of Y+ value
  #3
xiang
Guest
 
Posts: n/a
  Reply With Quote

Old   February 6, 2004, 20:31
Default Re: Influence of Y+ value
  #4
xiang
Guest
 
Posts: n/a
Thank you very much. I will look into the near wall carefully.
  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Gravity (g) Influence on Simulation Results Colin FLUENT 12 September 23, 2015 10:45
Region on influence in ansys meshing ATOTA ANSYS Meshing & Geometry 0 November 17, 2010 16:31
influence of the hydrostatic pressure pdz711 FLUENT 0 June 16, 2008 04:38
influence clogging in porous media budiharto FLUENT 0 July 27, 2005 10:06
Gravity g's influence on Simulation Results Colin Main CFD Forum 6 November 2, 2003 15:13


All times are GMT -4. The time now is 20:48.