 |
 |
 |
|
|
|
[Sponsors] | ||||
February 3, 2004, 14:37
|
O-type quadrilateral meshing
|
#1 |
|
Guest
Posts: n/a
|
I wanted to use O-type meshing. Can anyone plz tell me how to do O-type meshing.
Hatta |
|
|
||
|
February 4, 2004, 04:04
|
Re: O-type quadrilateral meshing
|
#2 |
|
Guest
Posts: n/a
|
Hi!
Tell us what geometry you want to mesh. You didn't mention that in this and in your past mail. I can only guess it's a round pipe... MATEUS |
|
|
|
||
|
February 9, 2004, 11:06
|
Re: O-type quadrilateral meshing
|
#3 |
|
Guest
Posts: n/a
|
I am working on a curved tube at presently having tube dia as 10 mm and coil dia as 100 mm with pitch 15 mm pitch and one turn.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Free jet simulation | msarkar | OpenFOAM Running, Solving & CFD | 39 | May 11, 2021 13:21 |
| boundary conditions for simpleFoam calculation | foam_noob | OpenFOAM Running, Solving & CFD | 8 | July 1, 2015 08:07 |
| [Other] cgnsToFoam problems with "QUAD_4" cells | lentschi | OpenFOAM Meshing & Mesh Conversion | 1 | March 9, 2011 04:49 |
| turbulent jet simulation | antonio_ing | OpenFOAM Running, Solving & CFD | 5 | September 16, 2010 02:31 |
| pipe flow with heat transfer | Fabian | OpenFOAM | 2 | December 12, 2009 04:53 |
Linear Mode
