Surfaces
 

Hi all,

I want to divide my model into a number of surfaces so that I can determine the mass flow rates across these surfaces.

I want two radial surfaces but I only want them in one section of the model. The radial surfaces, created through surface/iso-value/grid/radial coordinate, go through the entire length of the model where as I only want it in one section of the model.

Is there a way to create a radial surface in only one section of the model?

Regards,

Mark

Re: Surfaces
 

Try to combine iso-surface and iso-clip.

HV

Thanks it worked
 

Thanks HVN,

That worked!!