|
[Sponsors] |
February 13, 2004, 08:38 |
matching-tolerence
|
#1 |
Guest
Posts: n/a
|
Hi agian, I need some information about matching-tolerence as well.Could you help me please Best Regards
|
|
February 17, 2004, 03:49 |
Re: matching-tolerence
|
#2 |
Guest
Posts: n/a
|
Hi,
Matching-tolerance is a kind of clearance. When you define periodic boundary condition in Fluent, the nodes of both faces need to being exactly matched. However sometimes exported mesh from GAMBIT , the linked mesh is not exactly matched. So we use the Matching-tolerance. Inputing a large value compared with default,it's O.K. You will make a periodic condition. If you still aren't able to make a periodic condition, you have to use make-hanging-interface function. Thank you FJ |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] jagged, ragged edges... | ziemowitzima | OpenFOAM Meshing & Mesh Conversion | 138 | July 23, 2012 23:41 |
Cyclic boundary matching - help needed | Robert_B | STAR-CD | 5 | June 15, 2011 08:03 |
unexpected EOF while looking for matching | sweety zhong | FLUENT | 0 | August 1, 2006 10:37 |
Edge matching | Jens | CFX | 3 | March 14, 2002 12:37 |
Grid refinement with wall functions | Mark Render | Main CFD Forum | 8 | May 2, 2000 07:09 |