Home > Forums > Software User Forums > ANSYS > FLUENT

Lewis Number

Mark Forums Read

Reply

Search this Thread

March 1, 2004, 10:24	Lewis Number	#1
Newbie Guest Posts: n/a	Hi, Can anyone tell me how to determine/change the lewis number used in a Fluent modelling of non-premixed turbulent methane/air combustion? How do I know what lewis number fluent is using??? I'm not sure if using unity lewis number is acceptable, can anyone advise me? thanx, Newbie

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[mesh manipulation] Mesh Refinement	Luiz Eduardo Bittencourt Sampaio (Sampaio)	OpenFOAM Meshing & Mesh Conversion	42	January 8, 2017 12:55
DecomposePar unequal number of shared faces	maka	OpenFOAM Pre-Processing	6	August 12, 2010 09:01
[blockMesh] BlockMeshmergePatchPairs	hjasak	OpenFOAM Meshing & Mesh Conversion	11	August 15, 2008 07:36
Unaligned accesses on IA64	andre	OpenFOAM	5	June 23, 2008 10:37
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 04:15

All times are GMT -4. The time now is 08:09.