|March 9, 2004, 14:18||
I'm modelling species transport with fluid flow in intersecting cylinders, with a constant concentration at the inlet. My question concerns the treatment of the wall concentration. Fluent will only allow a either a zero flux or a specified value of wall concentration. However, a more realistic treatment at the wall involves specifying a solute flux entering the wall in terms of fluid side solute concentration and a wall permeability function.
The flux equation is of the form:
q = -D*(delta C / delta n) @ the wall
= k*Cw, where Cw is the wall concentration and k is a constant wall permeability
Do I need a UDF to model this flux? If so, I would really appreciate a few pointers on how to go about this. I am aware of a HEAT_FLUX UDF. Can this be used to model species transport?
Any help or advice would be greatly appreciated,
All the best,
|Thread||Thread Starter||Forum||Replies||Last Post|
|UDF parallel error: chip-exec: function not found?????||shankara.2||Fluent UDF and Scheme Programming||1||January 16, 2012 23:14|
|How to add a UDF to a compiled UDF library||kim||FLUENT||3||October 26, 2011 21:38|
|Dynamic Mesh UDF||Qureshi||FLUENT||1||December 2, 2009 01:27|
|UDF...UDF...UDF...UDF||Luc SEMINEL||FLUENT||0||November 25, 2002 05:03|
|UDF, UDF, UDF, UDF||Luc SEMINEL||Main CFD Forum||0||November 25, 2002 05:01|