|
[Sponsors] |
March 27, 2004, 03:13 |
Re:reynolds number
|
#1 |
Guest
Posts: n/a
|
Hi To select a solution for modeling of turbulent flows is depended to condition of problems. for example : k_e method has a range to apply and when reynolds shear stresses are more noticable , its realy imprtant to used this method.but this method has not enough efficiency in rotational and unbuonded flows . RSM method is good and accurate method for recognizing properties of average flow and reynolds stress. but it computing cost is hight.(it has seven partial differential equation more). amir.
|
|
March 27, 2004, 09:04 |
Re:reynolds number
|
#2 |
Guest
Posts: n/a
|
hi,
just as an indication, RSM increases your computing cost by 30 to 50% roughly. David |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[mesh manipulation] Mesh Refinement | Luiz Eduardo Bittencourt Sampaio (Sampaio) | OpenFOAM Meshing & Mesh Conversion | 42 | January 8, 2017 12:55 |
DecomposePar unequal number of shared faces | maka | OpenFOAM Pre-Processing | 6 | August 12, 2010 09:01 |
[blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 07:36 |
Unaligned accesses on IA64 | andre | OpenFOAM | 5 | June 23, 2008 10:37 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |