Conjugate heat transfer in a counter flow heat exchanger

abhijithmohan · March 22, 2014, 03:29

I am having a problem with my counterflow heat exchanger analysis in ansys fluent(conjugate heat transfer). After designing in the ansys design modeler and meshing it, and while setup was made it was found that heat transfer is not taking place between the fluid-solid interface. Later on I found that the Wall shadow was not generated at the interface.how to generate the wall shadow in this case.Thanks in advance ..

aditya92in · March 22, 2014, 12:43

Hi,

Change the domain type..to wall..it slit the zone to a coupled wall...like if the zone type is interface...change it to wall

abhijithmohan · March 23, 2014, 08:10

thanku adityaa..

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
mass flow in is not equal to mass flow out	saii	CFX	12	March 19, 2018 05:21
Conjugate Heat Transfer: Wall Heat Flux at Coupled Walls?	MaxHeat	FLUENT	4	September 14, 2017 10:44
Quenching simulation : how to set up a conjugate heat transfer between solid&liquid	Rockda	FLUENT	24	August 30, 2016 06:33
Pipe Flow Heat Transfer	Saima	CFX	5	January 30, 2011 16:41
Convective / Conductive Heat Transfer in Hypersonic flows	enigma	Main CFD Forum	2	November 1, 2009 22:53

March 22, 2014, 12:43		#2
aditya92in New Member anonymous Join Date: Mar 2014 Posts: 11 Rep Power: 12	Hi, Change the domain type..to wall..it slit the zone to a coupled wall...like if the zone type is interface...change it to wall

March 23, 2014, 08:10		#3
abhijithmohan New Member Abhijith Mohan Join Date: Mar 2014 Posts: 12 Rep Power: 12	thanku adityaa..