 |
 |
 |
|
|
|
[Sponsors] | ||||
May 9, 2004, 04:54
|
Temperature limitation
|
#1 |
|
Guest
Posts: n/a
|
Hello all
When I run the fluent model, I am getting following message. "temperature limited to 5.000000e+03 in 475 cells on zone 3 in domain 1" Why temperature is limiting to 5000K in my model. As per my knowledge, I am nowhere restricting it to 5000. But like this I want to fix my temperature rise to 1500K. Is it possible to fix like this. I am using species transport model. Regards Karthick |
|
|
||
|
May 10, 2004, 06:14
|
Re: Temperature limitation
|
#2 |
|
Guest
Posts: n/a
|
Go to....
SOLVE>CONTROLS>LIMITS You may find with further iterations that this high tempertaure limitation will go away. Solve using first order to convergence and then try second order. |
|
|
|
||
|
May 10, 2004, 08:12
|
Re: Temperature limitation
|
#3 |
|
Guest
Posts: n/a
|
Thanx Tom. It worked well
Regards Karthick |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem with zeroGradient wall BC for temperature - Total temperature loss | cboss | OpenFOAM | 12 | October 1, 2018 06:36 |
| Calculation of the Governing Equations | Mihail | CFX | 7 | September 7, 2014 06:27 |
| k residual goes up after temperature limitation warning??? | Catthan | FLUENT | 0 | November 24, 2010 17:48 |
| temperature limitation? | Deadly | FLUENT | 6 | August 7, 2002 22:29 |
| how to overcome the temperature limitation | fanadam | FLUENT | 3 | June 17, 2002 04:39 |
Linear Mode
