CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   DPM_evaporation (http://www.cfd-online.com/Forums/fluent/33708-dpm_evaporation.html)

MOONA May 12, 2004 07:00

DPM_evaporation
 
Hi folks,using pressure swirl atomizer in research system(spray dryer), but I have not evaporation in droplets. Also replace this atomizer with air blast atomizer,but in this model have not evaporation too .All using equation is right(inlet air temperature is 154 and water temperature falling from atomizer is 18 degree centigrade).What is problem in my system?

Thanks in advance

Thanks.

Diego June 4, 2004 14:43

Re: DPM_evaporation
 
Do you have the customs lwas activated?(in the injection panel). I the custom lwas you have to select inert heating, vaporization and boiling... i think, Best Regards, Diego


All times are GMT -4. The time now is 03:41.