|June 5, 2004, 10:13||
Re: 3D airfoil
First of all you may want to model only half wing in order to save time.
You can build a 3-D box with the wing attached to one of the walls and define that plane as symmetry. Make sure the box is large enough to prevent boundary effects (say 10 chords length before and after the wing).
Now the requested wing profile (NACA whatever) can be found on many sites as a list of x,y points. In gambit you should look for an option to create vertexes from file.
This should solve your prolem...
|Thread||Thread Starter||Forum||Replies||Last Post|
|Low Speed Airfoil||Mancusi||FLUENT||7||April 3, 2014 06:11|
|[GAMBIT] Meshing airfoil using .dat file problem||creggie||ANSYS Meshing & Geometry||10||June 27, 2010 19:24|
|Poor Residuals at Intersection Between Symmetry Plane and Airfoil Leading Edge||TWaung||CFX||2||February 16, 2010 09:11|
|Modeling Backflow for a 3D Airfoil (Wing of Finite Span)||Josh||CFX||9||August 18, 2009 11:31|
|Airfoil boundary condition||Frank||Main CFD Forum||1||April 21, 2008 18:36|