Spiece model problem!!
 

Hi, I have some problem about execute Fluent code for heat transfer under combustion model.

The Physical domain is shown in the attached file.The inner tube is specified as combustion model, and the heat will transfer through the wall to the outer tube, the liquid water is used as coolant.

The combustion model is OK, but I can not specified the material ¡Vwater in the Fluent solver. How should I do?

Re: Spiece model problem!!
 

In Gambit specify the volume though which water flows as a FLUID CONTINUUM. Then in fluent specify this continuum as water.

Best Luck next time!

Re: Spiece model problem!!
 

But, boundary condition panel fluid type can't not set material name in spiece model. How should I set the material name in fluid panel?