|June 26, 2004, 05:05||
I am still in the course of my research program and am hoping that you can help me once again.
I am about to survey the river that i hope to model in fluent and the result of this will be a large number of coordinates (x, y, z) giving a basis for a topograhical model of the river bed. I will then be able to generate nodes a edges from these using the MATLAB program and this will result in an ASCII file. My question then: is there any way that I would be able to read this file straight into gambit or fluent so that I do not have the tedious task of connecting the nodes and edges by hand.
In the same way, once the nodes and edges have been created, is there a method for automatically defining the faces so that this need not be done manually.
any advice you can give would be a great help.
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] surface mesh merging problem||everest||ANSYS Meshing & Geometry||44||April 14, 2016 06:41|
|Converting Starccm+ mesh||Ladnam||OpenFOAM||0||September 14, 2011 06:30|
|Meshing aifoil in ICEM||student123a||ANSYS Meshing & Geometry||13||December 8, 2010 11:40|
|2d irregular grid||Remy||Main CFD Forum||1||December 22, 2008 05:49|
|basic of mesh refinement||arya||CFX||4||June 19, 2007 12:21|