CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > FLUENT

how to disable residual checkbox with text command

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   July 14, 2004, 12:09
Default how to disable residual checkbox with text command
  #1
zago
Guest
 
Posts: n/a
hi everybody!

i want to run a simulation at a unix computer via secure shell. the file should run a couple of iterations with the laminar model, switch to k-e model, do some iterations again and finally switch to rsm-model.

i have a batch file that includes commands for reading the cas file, changing the model and writing the file after finished. i have detected that the simulation will only work corret if i add commands to enable the residual checkboxes after switching the turbulence model. otherwise the calculation will switch to the next model after some iteration (when reaching the convergence criterion).

there are no specific commands for disabeling the checkboxes in the fluent 6.1 text command list. when writing a journalfile the information "CheckButton" and the number of the button is given.

can somebody help me?

zago
  Reply With Quote

Old   July 15, 2004, 22:59
Default Re: how to disable residual checkbox with text com
  #2
venugopal
Guest
 
Posts: n/a
Haai, This is possible in Fluent. First you go to solve - monitors-residual-check-convergence?. After this command it will ask like this

/solve/monitors/residual> check-convergence

Check convergence of continuity residuals? [yes] no

Check convergence of x-velocity residuals? [yes] no

Check convergence of y-velocity residuals? [yes] no

Check convergence of z-velocity residuals? [yes] no

Check convergence of energy residuals? [yes] no

Check convergence of nut residuals? [yes] no

If you are giving "no" means it will deselect and yes means it will select. So, in your batch file you type the first command from above list and type 'y' or 'n' in your batch file as a next command to select or deselect respectively. I hope it should work.

  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Extrusion with OpenFoam problem No. Iterations 0 Lord Kelvin OpenFOAM Running, Solving & CFD 8 March 28, 2016 12:08
How to write k and epsilon before the abnormal end xiuying OpenFOAM Running, Solving & CFD 8 August 27, 2013 16:33
Orifice Plate with a fully developed flow - Problems with convergence jonmec OpenFOAM Running, Solving & CFD 3 July 28, 2011 06:24
Differences between serial and parallel runs carsten OpenFOAM Bugs 11 September 12, 2008 12:16
Unknown error sivakumar OpenFOAM Pre-Processing 9 September 9, 2008 13:53


All times are GMT -4. The time now is 11:59.