|
[Sponsors] |
July 20, 2004, 12:41 |
Fillet meshing
|
#1 |
Guest
Posts: n/a
|
Dear all,
As I know, Fluent use linear cells but not high order elements. Ok, despite the boundary layer construction, in the case of non linear geometry like a radius would the geometry be approximated to a straight edge(s) corresponding to the cell edge size? Or it is a graphics resolution? Thanks a lot Khalid |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing | David-CFD | ANSYS Meshing & Geometry | 1 | April 1, 2011 06:22 |
Best Meshing scheme for Cylinder | Nutrex | Main CFD Forum | 4 | July 29, 2008 12:03 |
Meshing locks workbench window. | andy2o | CFX | 0 | February 1, 2008 06:01 |
Singularity of grid?Volume meshing vs face meshing | Ken | Main CFD Forum | 0 | September 4, 2003 12:09 |
Volume Meshing & Face Meshing? singularity of grid | ken | FLUENT | 0 | September 4, 2003 12:08 |