|
[Sponsors] |
July 24, 2004, 04:59 |
Writing profiles
|
#1 |
Guest
Posts: n/a
|
I've taken a simple 2D model with constant wall heat transfer coefficient=1000 W/m2K. When I tried to write the profile of heat transfer coefficient on that wall, the values ranging from 250-450 W/m2K were written to the profile file and the same values are displayed in the contour graph also. And these values do not coincide with the values given as input.(1000W/m2K)
What I am thinking is it is not taking the heat transfer coefficient values in the boundary condition panel at all. Thanks in advance Ravi |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
solid to fluid heattransfer with chtMultiRegionFoam | nakor | OpenFOAM | 11 | March 21, 2011 09:28 |
Time-Varying Temperature Profiles | shepardsp | ANSYS | 3 | October 17, 2010 15:36 |
Gas flow profiles in mixing tank | srinivas | FLUENT | 0 | November 8, 2006 05:52 |
Fatal error error writing to tmp No space left on device | maka | OpenFOAM Installation | 2 | April 3, 2006 09:48 |
Velocity profiles | Rex | FLUENT | 4 | July 23, 2002 20:35 |