|September 20, 2004, 20:55||
Boundary layers problem
I've been trying to define boundary layers on different solid faces that bathe in a fluid contained in a cylindrical chanel.
I'm trying to define then boundary layers that go into the fluid volume but I always get the arrow and the boundary layer itself pointing into the solid volumes. If I want to change the direction of the arrow by SHIFT+CENTER click the boundary layer disappears or I get a boundary layer with no rows at all.
I have no trouble to create BLs on the chanel walls pointing in the right direction, but I'm unable to do the samething on the solid volumes that are contained inside the cilinder.
Thanks in advance.
|Thread||Thread Starter||Forum||Replies||Last Post|
|[GAMBIT] 3D boundary layer and meshing problem in GAMBIT 2.4.6||prashanthreddyh||ANSYS Meshing & Geometry||1||December 20, 2011 01:35|
|Internal boundary problem||stefanke||OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ...||2||May 24, 2011 02:21|
|Import problem||ARC||Open Source Meshers: Gmsh, Netgen, CGNS, ...||0||February 27, 2010 11:56|
|Gambit 2 Boundary Layers||An Modh Coinniolach||FLUENT||2||January 30, 2002 12:54|
|Problem with periodic boundary layers||Phil||FLUENT||15||October 2, 2000 14:56|