CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   Postprocessing (http://www.cfd-online.com/Forums/fluent/34733-postprocessing.html)

joe September 30, 2004 08:33

Postprocessing
 
Hi,

I am trying to get an output file over the coordinates positions (x,y,z) along a line on the surface of my model. Created a line and can plot/write (2D xy-plot), for example the pressure, along this line but would also like the coordinates of the surface to be able to draw the contours of the surface in for example Matlab.

How do I do this?

Best Regards Joe

Frasier Crane October 3, 2004 07:47

Re: Postprocessing
 
I don't know how to do that in fluent but i know how to do that in matlab if you got a picture file (*.bmp, *jpg) with your information, check out the digitize2.m file in file exchage section under image processing from the mathworks website. I hope this helps!

FC

If you do it with fluent it will be easier.


All times are GMT -4. The time now is 18:26.