CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > FLUENT

dual enclosed loop projections

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   October 16, 2004, 06:43
Default dual enclosed loop projections
  #1
matt
Guest
 
Posts: n/a
hello,

trying to mesh a large rectangular tank (3D) with a relatively small circular inlet at one end and an identically shaped outlet at the other outlet is slightly offset from inlet

after many decompositions, etc. I am recieving messages s/a:

"dual intersecting enclosed loop projections not handled yet" and "dual enclosed loop projections not implemented yet"

not even sure where to begin with this issue - perhaps, what are these loop projections and how to handle/implement them ?

any insight will be greatly appreciated - thank you

  Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Problem with Gmsh nishant_hull Open Source Meshers: Gmsh, Netgen, CGNS, ... 23 August 5, 2015 02:09
Superlinear speedup in OpenFOAM 13 msrinath80 OpenFOAM Running, Solving & CFD 18 March 3, 2015 06:36
recover solution from dual grid jamesproctor Main CFD Forum 0 July 30, 2010 15:31
my stl surface is seen as just a line rcastilla OpenFOAM Meshing & Mesh Conversion 2 January 6, 2010 02:30
NACA0012 geometry/design software needed Franny Main CFD Forum 13 July 7, 2007 15:57


All times are GMT -4. The time now is 14:23.