|
[Sponsors] |
October 26, 2004, 13:51 |
convergence problem
|
#1 |
Guest
Posts: n/a
|
I am doing simulation on a laminar flow in a capillary tube. However, i have problems on convergence. At first instance, the mass continuity residual increase and i lower the under-relaxation factor as suggested by the Fluent Guide book. It seems alright buy after about 200 iterations, the residual starts to increase again, from 2.5e-2 to 3.2e-2. May i know what's the possible problem again? Do i need to stop and again lower the under relaxation factor? or any othe rpossible reasons?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
convergence problem when use pisoFoam, LES for wind tunnel case | Forrest_Lei | OpenFOAM | 3 | July 19, 2011 06:00 |
convergence problem | commonyue | Main CFD Forum | 1 | December 1, 2009 03:54 |
Convergence of CFX field in FSI analysis | nasdak | CFX | 2 | June 29, 2009 01:17 |
3D Fluid Flow Convergence problem | Emily | FLUENT | 2 | March 21, 2007 22:18 |
Non Convergence of 3D Heat transfer cfd problem | Balraj | Main CFD Forum | 3 | December 9, 2004 00:24 |