CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   FLUENT (https://www.cfd-online.com/Forums/fluent/)
-   -   grid generation problem (https://www.cfd-online.com/Forums/fluent/34930-grid-generation-problem.html)

nabeel mohsin October 27, 2004 02:26

grid generation problem
 
hi, when i import cad file in step format i found problem in grid generation.The error is having small gaps. can tell me how i can handle these error nabeel

Jason October 27, 2004 09:29

Re: grid generation problem
 
It depends on the problem. Is the step file and assembly, and the gaps are small overlaps from the CAD output (usually on the order of 10^-4 or 10^-5)? If this is the case, it's usually best to go back to the original CAD program. In Pro/E we go back and either create a control volume and subtract our parts from it, or we merge the parts together (depending on what we have modeled in Pro/E). These overlaps are then removed by the CAD program and you have a single volume. This might help if you're having problems with a single part as well.

The other common cause is a small gap that is intentional. Let's say you have a missile in a freestream flow with 4 canards (or any other lifting surfaces) sticking out of the missile body and there's a 1/8" gap between the base of the canard and the missile body. Sometimes Gambit will have problems meshing this area. To get around this, split any of these small gaps into their own volumes. For the example I just gave, I would try sweeping the edges of the base of the wing until they intersect the missile body, and then splitting the control volume with these new faces.

If you have any more info on what you're doing, or if you can see where the problem is, just post it and I'll try to help more if I can.

Good luck, Jason

Kiran November 4, 2004 03:58

Re: grid generation problem
 
If you have generated your model in Pro/E, go to tools -> options....Uncheck where it says "show only options loaded from file"...Then click on accuracy lower bounds and change it to 1e-06 (0.000001)...click OK.Then go to edit -> set up -> accuracy and change the accuracy to 0.000001.say "yes" when it asks whether you want it regenerated.While exporting the STEP file export the solids/shells.Hope this helps!!! regards, -Kiran


All times are GMT -4. The time now is 08:14.