 |
 |
 |
|
|
|
[Sponsors] | ||||
December 1, 2004, 06:30
|
Rotational speed
|
#1 |
|
Guest
Posts: n/a
|
Hi there,
I am studying a wells-turbine. This turbine is running at high rpm. I know the inlet and outlet boundary conditions. The problem is that I dont know how to give a rotational speed to the turbine. If I only set inlet and outlet boundary conditions the results are like the turbine was stopped. What to do? Thanks |
|
|
||
|
December 1, 2004, 23:38
|
Re: Rotational speed
|
#2 |
|
Guest
Posts: n/a
|
Checkout about MRF...
-guru. |
|
|
|
||
|
December 3, 2004, 08:38
|
Re: Rotational speed
|
#3 |
|
Guest
Posts: n/a
|
You must set the fluid zone as the rotation zone.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Train Speed | yeo | FLUENT | 5 | February 14, 2012 08:38 |
| Can sliding mesh use varying rotational speed? | Shengyi | FLUENT | 1 | February 14, 2009 16:01 |
| rotational speed to wall zone | cosimo | FLUENT | 0 | August 23, 2006 10:07 |
| (CFX POST) Rotational Speed | ARJUN | CFX | 9 | July 13, 2006 20:38 |
| udf in MRF to update the rotational speed | Jam | FLUENT | 0 | August 21, 2005 12:50 |
Linear Mode
