|
[Sponsors] |
December 20, 2004, 13:51 |
Spray combustion validation
|
#1 |
Guest
Posts: n/a
|
Hello!
has anyone done a complete validation of a spray combustion calculation? Velocity field/Temperature profile, volume flux, droplet velocity,D10/D32? I was trying to match the volume flux with the one obtained experimentally by increasing the number of particle streams but then my temperature profile becomes wrong! But when my number of particle streams is quite low with a wrong volume flux, my temperature profile looks in reasonable agreement with the experimental data. If anyone has dealed with spray validation before, I would be very grateful to receive some advice from your side. Thank you very much Regards David |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Two-Phase Flow in Spray Combustion | Vajira | Main CFD Forum | 4 | November 4, 2017 14:31 |
Simulate spray without Combustion | flying | OpenFOAM Running, Solving & CFD | 7 | June 11, 2010 20:34 |
Multifuel Diesel Spray and Combustion | usker | Siemens | 12 | December 1, 2007 20:08 |
diesel engine spray and combustion | usker | Siemens | 6 | April 24, 2006 23:36 |
Spray and combustion model for alternative fuel | Torn | Main CFD Forum | 3 | November 12, 2003 05:05 |