CFD Online Discussion Forums

CFD Online Discussion Forums (
-   FLUENT (
-   -   error in Grid Interface (

chandra January 6, 2005 23:33

error in Grid Interface
Hai everyone, i simulate a steam turbine in 2D and next for 3D, but there was a error (violation, error) when geometri of stator and rotor (already merge using 2dtmerge for sliding mesh) was defined for interface.

Is the problem comes from periodicy of geometri? because the geometri stator and rotor not enough/good to be a periodic gemetry?


zxaar January 7, 2005 03:18

Re: error in Grid Interface
some times just after interface creation the mesh check fails due to left hand right hand faces , you can fix this in fluent command prompt by




All times are GMT -4. The time now is 23:01.