CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > FLUENT

error in Grid Interface

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   January 6, 2005, 23:33
Default error in Grid Interface
  #1
chandra
Guest
 
Posts: n/a
Hai everyone, i simulate a steam turbine in 2D and next for 3D, but there was a error (violation, error) when geometri of stator and rotor (already merge using 2dtmerge for sliding mesh) was defined for interface.

Is the problem comes from periodicy of geometri? because the geometri stator and rotor not enough/good to be a periodic gemetry?

thanks
  Reply With Quote

Old   January 7, 2005, 03:18
Default Re: error in Grid Interface
  #2
zxaar
Guest
 
Posts: n/a
some times just after interface creation the mesh check fails due to left hand right hand faces , you can fix this in fluent command prompt by

grid

modify-zones

repair-face-handedness

  Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
grid interface problems: ydzhang FLUENT 7 May 9, 2013 12:09
Interface w. Pitch Change: Thcfd CFX 0 December 22, 2010 04:50
RPM in Wind Turbine Pankaj CFX 9 November 23, 2009 05:05
How work with grid interface?? teguhtf FLUENT 12 October 29, 2009 02:56
Troubles modelling flow through a grid Hans Klaufus CFX 1 June 28, 2000 16:43


All times are GMT -4. The time now is 13:19.