Home > Forums > Software User Forums > ANSYS > FLUENT

how to mesh the tip region of cyclone?

Mark Forums Read

Reply

Search this Thread

January 8, 2005, 07:42	how to mesh the tip region of cyclone?	#1
Lcw Guest Posts: n/a	when I mesh this region,always exit 1-2 failed highly skewed meshes,even if no failed mesh, the maxmum skew is about 0.78. how to do it well? thank you for giving some advice.

January 8, 2005, 07:46	Re: how to mesh the tip region of cyclone?	#2
Lcw Guest Posts: n/a	correction: the maxmum skew is about 0.97

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
problem with Min/max rho	tH3f0rC3	OpenFOAM	8	July 31, 2019 09:48
[Gmsh] 2D Mesh Generation Tutorial for GMSH	aeroslacker	OpenFOAM Meshing & Mesh Conversion	12	January 19, 2012 03:52
Problem in defining porous region on an imported tetrahedral mesh	run_cfd	OpenFOAM Pre-Processing	0	May 24, 2011 02:15
Convergence moving mesh	lr103476	OpenFOAM Running, Solving & CFD	30	November 19, 2007 14:09
[Gmsh] Import gmsh msh to Foam	adorean	OpenFOAM Meshing & Mesh Conversion	24	April 27, 2005 08:19

All times are GMT -4. The time now is 00:42.