|February 17, 2005, 09:15||
Basic mutli component question
I am used to calculating single gaz flow but when it comes to multi-species, I am utterly neophyte.
I've been reading FLUENT manual and have some questions after that.
First, my problem, I have 2 entries, one MASS FLOW INLET of air, another MASS FLOW INLET of water vapour and a PRESSURE OUTLET.
My problems are the following :
- What should I enter in the field : Define>Models>Species>Mixture Template, knowing that I imported water vapour and air from the database? - How do I do to select water vapour and air for my 2 boundary conditions, knowing that Fluent asks me to chose between O2 and H2O only when trying to specificate the boundary condition? - What should I select as an option knwoing that I don't want any chemical reaction and would only like to simulate the exchanging of heat between the 2 gas?
Thank you in advance for answering, even partially, my questions.
|Thread||Thread Starter||Forum||Replies||Last Post|
|basic question||chelvistero||OpenFOAM||5||April 8, 2010 04:53|
|basic question contour plot in paraview||Kate||OpenFOAM Paraview & paraFoam||6||March 14, 2010 17:10|
|Basic question: UDF for wall heat flux||Carl||FLUENT||1||August 5, 2006 19:01|
|Basic Question on Convergence||Anshul||FLUENT||1||August 2, 2002 02:14|
|basic question from non-graduate||becky||Main CFD Forum||5||November 19, 1999 05:14|