|
[Sponsors] |
March 10, 2005, 16:29 |
steve
|
#1 |
Guest
Posts: n/a
|
If I first create a mesh in GAMBIT and then modify (adapt) it in FLUENT and want to have a ".msh" version of the grid, I think I should first somehow export it to GAMBIT and then in GAMBIT save it as a ",msh" file. How can I do this? thx.
|
|
March 11, 2005, 03:34 |
Re: steve
|
#2 |
Guest
Posts: n/a
|
You can load from grambit the cas file. Luca
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problems with the RSM in simpleFoam | sberg | OpenFOAM Running, Solving & CFD | 10 | February 25, 2014 19:39 |
Master thesis proposition | hani | OpenFOAM | 19 | December 5, 2013 09:52 |
Mac Simple Install Request or Processing Assistance Help | sjohnson | OpenFOAM Installation | 4 | December 12, 2008 07:46 |
[Commercial meshers] Wrong face orientations after conversion from fluent mesh | stevecollie | OpenFOAM Meshing & Mesh Conversion | 6 | July 14, 2008 07:20 |
steve | dynamic LES | Main CFD Forum | 0 | April 4, 2005 08:38 |