|March 17, 2005, 06:14||
Coarsen 3D Grid ??
Hello fellow Fluent users,
Is it possible to coarsen a 3D grid in Fluent at all? according to the manual (23.8.3) not really: "Note that if you are using hanging node adaption (the default), you will not be able to create a grid that is coarser than the original grid. For this, you must use conformal adaption. Note also that conformal coarsening is only available for 2D or axisymmetric geometries."
I want to adapt my grid to correct Y+ values, however I can only refine it..
Any comments would be greatly appreciated
|Thread||Thread Starter||Forum||Replies||Last Post|
|MapFields to New Grid For Extreme Grid Deformations due to Body Motion||albcem||OpenFOAM||0||May 5, 2009 14:17|
|Grid Adaptation||Suresh||FLUENT||0||October 15, 2003 13:18|
|GRID TO GRID INTERPOLATION in FLUENT||calogero||FLUENT||3||June 4, 2003 08:32|
|Combustion Convergence problems||Art Stretton||Phoenics||5||April 2, 2002 05:59|
|Troubles modelling flow through a grid||Hans Klaufus||CFX||1||June 28, 2000 16:43|