|
[Sponsors] |
March 25, 2005, 06:57 |
Gambit problem
|
#1 |
Guest
Posts: n/a
|
Please, help. I've already spent a day on it. I have a simple 2D geometry that consists of two splitted faces. I want to copy this geometry 3 times. I'm doing copy with mesh unlinked and copy zone types on. Then I've connected the the mutual edges. The wall (which is a mutual boundary between the two zones, say fluid and solid) is not defined as coupled in Fluent and does not permit heat flux through it. What do you think the problem is?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gambit geometry problem | cestrin | FLUENT | 3 | July 4, 2012 02:33 |
[Commercial meshers] Problem with Mesh conversion Gambit msh Foam | Rachid BANNARI (Bannari) | OpenFOAM Meshing & Mesh Conversion | 25 | September 11, 2011 07:58 |
Gambit installation problem | Panos | FLUENT | 4 | March 5, 2009 22:44 |
Problem meshing with Gambit | Adrian | FLUENT | 8 | October 7, 2008 08:39 |
Startup Problem in Gambit 2.2 with WindowXP | Win Win Maw | FLUENT | 3 | January 25, 2006 11:09 |