|
[Sponsors] |
March 24, 2005, 08:09 |
divergence detect in AMG
|
#1 |
Guest
Posts: n/a
|
Hi everyone
Some error occured in my simulation when I add mass source to two phase flow. After the sources were added the solver give the follow info: divergence detect in AMG: pressure correction. I don't what it means. Anyone can give some help BR Erica |
|
March 24, 2005, 09:28 |
Re: divergence detect in AMG
|
#2 |
Guest
Posts: n/a
|
I am getting the similar thing in my simulation Did you correctly specify the source term both A and B part? Decrese the urf this might help you. Z
|
|
March 25, 2005, 02:58 |
Re: divergence detect in AMG
|
#3 |
Guest
Posts: n/a
|
I encountered the same problem. I think you should check your BC.
|
|
March 31, 2005, 15:01 |
Re: divergence detect in AMG
|
#4 |
Guest
Posts: n/a
|
Check your source term and verify if its dimensions are right. Remember you have to refer it to the unit volume.
Best regards, ap |
|
April 2, 2005, 03:58 |
Re: divergence detect in AMG
|
#5 |
Guest
Posts: n/a
|
Thank you!
BR Erica |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Divergence detected in AMG solver: ads-0 | Patrino | FLUENT | 6 | May 12, 2022 03:11 |
Divergence in AMG solver! | marina | FLUENT | 20 | August 1, 2020 11:30 |
Error: Divergence detected in AMG solver | siri | FLUENT | 8 | March 12, 2018 17:08 |
Quarter Burner mesh with periosic condition | SamCanuck | FLUENT | 2 | August 31, 2011 11:34 |
AMG Solver divergence for LES | anindya | FLUENT | 0 | June 20, 2005 16:12 |