|
[Sponsors] |
April 5, 2005, 06:31 |
meshing problemes?!
|
#1 |
Guest
Posts: n/a
|
hello I have a problem when I meshing, surface of geometry, error message in GAMBIT is: mesh of face 1. contains 5 highly skewed elements (EQUISIZE SKEW>0.97) thus I cannot be continued please what is the solution?
|
|
April 5, 2005, 06:45 |
Re: meshing problemes?!
|
#2 |
Guest
Posts: n/a
|
Try to diminish the cell size
|
|
April 7, 2005, 06:13 |
Non Newtonian fluid
|
#3 |
Guest
Posts: n/a
|
hello everyone I have a problem, of non-Newtonian fluid, I can programming a nonNewtonian fluid which depend of the temperautre, in Fluent I uses the powerlaw model, then I does not understand what corresponds T0 and T in the exponential term think you.
|
|
April 7, 2005, 09:01 |
Re: Non Newtonian fluid
|
#4 |
Guest
Posts: n/a
|
see chapter 8.4.5 of the fluent manual.
|
|
April 8, 2005, 05:08 |
steady or unsteady state
|
#5 |
Guest
Posts: n/a
|
Hello everyone, please help. my problem is for choose steady and unsteady state, I have an flow with steady state and heat transfer with unsteady state & the flow is coupled with heat transfer, I have a diffecult to choose the conditions for resolve this problem. think you.
|
|
April 18, 2005, 08:59 |
Re: Non Newtonian fluid
|
#6 |
Guest
Posts: n/a
|
thanks
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing | David-CFD | ANSYS Meshing & Geometry | 1 | April 1, 2011 06:22 |
Best Meshing scheme for Cylinder | Nutrex | Main CFD Forum | 4 | July 29, 2008 12:03 |
Meshing locks workbench window. | andy2o | CFX | 0 | February 1, 2008 06:01 |
Singularity of grid?Volume meshing vs face meshing | Ken | Main CFD Forum | 0 | September 4, 2003 12:09 |
Volume Meshing & Face Meshing? singularity of grid | ken | FLUENT | 0 | September 4, 2003 12:08 |