|
[Sponsors] |
April 13, 2005, 03:12 |
MSH to DBS File
|
#1 |
Guest
Posts: n/a
|
Hi,
I want to convert MSH file to DBS file. I went to Import Mesh in gambit but somehow it does not work. Can some one pls tell me the right way to do it. Thanks. Sham. |
|
April 13, 2005, 06:01 |
Re: MSH to DBS File
|
#2 |
Guest
Posts: n/a
|
it should work, selet the 3d option if u r importing it (3d file,), and make sure u have select fluent mesh in import
|
|
April 14, 2005, 01:17 |
Re: MSH to DBS File
|
#3 |
Guest
Posts: n/a
|
I have tried so many time and it just does not work. what do you specify for the featured angle?
Sham. |
|
April 14, 2005, 18:20 |
Re: MSH to DBS File
|
#4 |
Guest
Posts: n/a
|
this sounds starnge, because reading .msh in gambit is one thing without which i could not survive, this is the answer to all my complicated cases, and i use this daily,
anyway, see if u can read the mesh in fluent, if u can read the mesh in fluent, u shall be able to read it in gambit, so if u can read it in fluent, save the cas file, and instead of .msh import the mesh by .cas file in gambit it shall work |
|
April 14, 2005, 21:23 |
Re: MSH to DBS File
|
#5 |
Guest
Posts: n/a
|
Thanks zxaar,
I have tried that and it gives the same error. It says.; Error encountered while reading the header information. Error: The FIdap neutral file header is non standard. Sham. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 19:08 |
ParaView Compilation | jakaranda | OpenFOAM Installation | 3 | October 27, 2008 11:46 |
[OpenFOAM] ParaView 33 canbt open OpenFoam file | hariya03 | ParaView | 7 | September 25, 2008 17:33 |
[OpenFOAM] Paraview command not found | hardy | ParaView | 7 | September 18, 2008 04:59 |
Compiling OpenFOAM13 on AMD64 with Redhat Enterprise | mbeaudoin | OpenFOAM Installation | 20 | June 17, 2008 06:43 |