ERROR!!

May 9, 2005, 04:09

I keep getting the error: TEMPERTAURE LIMITED TO 1 When does this occur and why??

May 9, 2005, 04:28

temperature limited to 1k means fluent has calculated a negative kelvin temperature. this makes no sense an therefore the lower temperature limit is used instead of the calculated value. you can set the limit for temperature, pressure etc. in solve->sontrol->limits. why does it occur? its hard to say. i observed this message sometimes during combustion modeling with an negative heat flux as wall bc.

rom

May 9, 2005, 04:09	ERROR!!	#1
Dhania Guest Posts: n/a	I keep getting the error: TEMPERTAURE LIMITED TO 1 When does this occur and why??

May 9, 2005, 04:28	Re: ERROR!!	#2
rom Guest Posts: n/a	temperature limited to 1k means fluent has calculated a negative kelvin temperature. this makes no sense an therefore the lower temperature limit is used instead of the calculated value. you can set the limit for temperature, pressure etc. in solve->sontrol->limits. why does it occur? its hard to say. i observed this message sometimes during combustion modeling with an negative heat flux as wall bc. rom

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh	gschaider	OpenFOAM Community Contributions	300	October 29, 2014 18:00
c++ libraries and solver compiling	vaina74	OpenFOAM Installation	13	February 3, 2012 17:43
Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug	unoder	OpenFOAM Installation	11	January 30, 2008 20:30
DecomposePar links against liblamso0 with OpenMPI	jens_klostermann	OpenFOAM Bugs	11	June 28, 2007 17:51
user defined function	cfduser	CFX	0	April 29, 2006 10:58