 |
 |
 |
|
|
|
[Sponsors] | ||||
May 12, 2005, 21:51
|
Who use FLUENT 6.2?
|
#1 |
|
Guest
Posts: n/a
|
There is someone using FLUENT 6.2? Maybe we can discuss about sth ralating dynamic mesh?
|
|
|
||
|
May 13, 2005, 02:57
|
Re: Who use FLUENT 6.2?
|
#2 |
|
Guest
Posts: n/a
|
Hi! I use dynamic mesh with Fluent. Tell us your probs. Luca
|
|
|
|
||
|
May 13, 2005, 03:40
|
Re: Who use FLUENT 6.2?
|
#3 |
|
Guest
Posts: n/a
|
Thanks.
My problem is: I need to simulate a pump. i use triangular mesh, in a basic plane, then extrude it with mesh, then construct a 3d model. for simulating the pump, i must use the 2.5d model of dynamic mesh. how to set correct the model's dynamic zones, to make it run. |
|
|
|
||
|
May 13, 2005, 03:44
|
Re: Who use FLUENT 6.2?
|
#4 |
|
Guest
Posts: n/a
|
you have to write a UDF and hook it yo the domain or the face thread you want to move. Please look at Fluent's UDF guide. You'll find a lot of things there.Luca
|
|
|
|
||
|
May 13, 2005, 04:31
|
Re: Who use FLUENT 6.2?
|
#5 |
|
Guest
Posts: n/a
|
If u don't mind, i email u my simple model and udf file, please check my setting. i check it many times, i think that it is correct, but it cannot run.
could u help me? |
|
|
|
||
|
May 13, 2005, 05:03
|
Re: Who use FLUENT 6.2?
|
#6 |
|
Guest
Posts: n/a
|
Yes OK, I'll give it a look. Luca
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fluent 6.2 tutorials | José Garcia | FLUENT | 17 | September 18, 2015 02:01 |
| Fluent jobs through pbs | ibnkureshi | FLUENT | 5 | June 9, 2011 13:43 |
| Modelling steam-dry reforming of methane in FLUENT 6.2. | Talliks | FLUENT | 0 | March 2, 2010 06:55 |
| Fluent 6.2 dynamic meshing | tiger | FLUENT | 1 | May 4, 2005 11:58 |
| PROBLEM with Fluent 6.2 | Luca | FLUENT | 4 | April 30, 2005 04:27 |
Linear Mode
