|
[Sponsors] |
May 31, 2005, 15:42 |
3D Distributor with Gambit
|
#1 |
Guest
Posts: n/a
|
Hi, I am trying to create a 3D geometry with a distributor. The difficulty is in meshing the entire geometry, the main flow section + distributor.Can anyone suggest?
Thanks, Sanjib |
|
May 31, 2005, 16:41 |
Re: 3D Distributor with Gambit
|
#2 |
Guest
Posts: n/a
|
Difficult to say from this. Depends on your geometry. If yr distributor is kind of plates with number of holes(fluid area) then mesh those holes first and then try to generate mesh for the whole domain.Ofcourse depends what kind of domain you have. -US
|
|
May 31, 2005, 19:05 |
Re: 3D Distributor with Gambit
|
#3 |
Guest
Posts: n/a
|
Thank you for your reply. That's eaxctly what I was trying to do. The distributor is like the one used for bubble columns, a circular plate with holes drilled into it with a column resting on the distributor. The problem is ,the distributor and the column has a common face, how to generate mesh in this geometry ?
|
|
May 31, 2005, 22:50 |
Re: 3D Distributor with Gambit
|
#4 |
Guest
Posts: n/a
|
Do you have windbox(portion below distributor)? In any case, you should have split distributor plate from the column domain and then hole surfaces from the distributor plate. Once you hv done so, mesh the holes with relatively smaller cells and then try meshing domain. By the way, what kind of elements you try to use for your grid? Probably, triangular since many small holes on the distributor. I think, there shouldn't be any problem with that. If not successful, could you find what error it gives? Regards, -US
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Converting Fluent mesh files to Gambit neutral files | samuelkc | ANSYS Meshing & Geometry | 9 | April 21, 2021 06:28 |
[GAMBIT] Canīt start GAMBIT | zalho | ANSYS Meshing & Geometry | 18 | April 8, 2019 01:05 |
Gambit help: Cube inside cube | Jack Martinez | FLUENT | 13 | August 11, 2010 06:29 |
Gambit 2.3.16, Xming or Exceed...HELP! | bambam3417 | FLUENT | 10 | May 7, 2010 12:39 |
Gambit -dev X11 doesn't work | Ervin Amet | FLUENT | 0 | October 28, 2007 08:33 |