|
[Sponsors] |
June 9, 2005, 02:12 |
3-Phase Modeling (Solid+water+air)
|
#1 |
Guest
Posts: n/a
|
In my problem a slurry(water+ dispersed solids) is entering from the inlet at the top of column. The air is entering from the bottom of column. The air and solid particles will collide. I am interested in collision efficeicy of these air buubles and solid particles. there are oulet for concenetrate at top and tails at bottom. i have problem in specifying the inlet condition of sluury as it is mixture of water and solids. i am using eulerian multiphase model.
If anybody can help me? Regards |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Free water jet impinging hot solid surface, including boiling | hamdy | Fluent UDF and Scheme Programming | 5 | August 19, 2012 19:52 |
Evaporatin water in the air | Morteza | FLUENT | 1 | August 20, 2008 05:04 |
Modeling of solid domains in fluent, no fluid flow | Satish Perivilli | FLUENT | 2 | December 1, 2005 11:41 |
Help!!!problems in air jet into water bath | kim | FLUENT | 4 | June 9, 2003 07:04 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |