|
[Sponsors] |
June 16, 2005, 14:50 |
volume meshin problem
|
#1 |
Guest
Posts: n/a
|
I am designing a cyclone separator. My solution diverges at the points where there is intersection of hex and tet meshing. I am not able to figure out the solution of this problem. Please help me in this. Thank you.
|
|
June 18, 2005, 06:34 |
Re: volume meshin problem
|
#2 |
Guest
Posts: n/a
|
You are using non-conformal hybrid mesh.Do you use interface between tow meshes? If yes, have you selected the smaller interface as interface_1?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Zero Volume Fraction in Free Surface Problem | marega | CFX | 1 | September 10, 2009 06:31 |
On the damBreak4phaseFine cases | paean | OpenFOAM Running, Solving & CFD | 0 | November 14, 2008 21:14 |
Volume mesh problem in STARDESIGN | Jaedal | Siemens | 2 | October 17, 2007 09:23 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |
volume mesh problem | Christophe | FLUENT | 10 | June 8, 2006 02:53 |