|
[Sponsors] |
July 2, 2005, 05:18 |
cyclic BC (diff. type) on the same wall
|
#1 |
Guest
Posts: n/a
|
Hi,
I need to apply heat flux and convection B.C. on the same wall, one after another, and it will go on cycling. To be clear: say, heat flux (no convection) will be applied a certain wall for the first x time steps followed by convection for next y setps (when heat flux is zero or deactivated). It will go on like this...... I just have tried the "heat flux turn on/off" part using DEFINE_PROFILE and it worked fine. Now my question is - since this macro is hooked from the B.C. panel, where only one kind of B.C. can be activated at a time, will it work if I write two diff. DEFINE_PROFILE macros and hook them accordingly? Would DEFINE_ADJUST be a better solution? Thanks. - Hasan |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
transsonic nozzle with rhoSimpleFoam | Unseen | OpenFOAM Running, Solving & CFD | 8 | July 1, 2022 07:54 |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 02:13 |
Need help with boundary conditions: open to atmosphere | Wolle | OpenFOAM | 2 | April 11, 2011 08:32 |
buoyantSimpleRadiationFoam | msarkar | OpenFOAM | 0 | February 15, 2010 07:22 |
[Other] StarToFoam error | Kart | OpenFOAM Meshing & Mesh Conversion | 1 | February 4, 2010 05:38 |