|
[Sponsors] |
July 8, 2005, 06:07 |
MESH
|
#1 |
Guest
Posts: n/a
|
Hi guys! I have meshed a very complicated geometry, and it happens that the mesh is not attached to the boudary layer but directly to the wall in a small part of it. Fluent reads it and the checking is ok. So I would like to know if this can be a problem or not. Thanks in advance for all your help! Antonella
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
Meshing aifoil in ICEM | student123a | ANSYS Meshing & Geometry | 13 | December 8, 2010 10:40 |
mesh missing after export in gambit | morteza08 | ANSYS Meshing & Geometry | 1 | July 26, 2010 01:10 |
2d irregular grid | Remy | Main CFD Forum | 1 | December 22, 2008 04:49 |