|July 17, 2005, 17:11||
Please Help with Critical Gambit Problem
I am meshing a very complex auditorium geometry in Gambit. I did all my virtual geometry clean-up, finally satisfied with a maximum equi-angle and equi-size skewnesses of about 0.90. However, when I export the mesh, I get the following error:
ERROR: An incorrect mesh has been stored. Check mesh quality before export.
I always check mesh quality before export. I also did a geometry and topology check, and mesh checks using equi-angle and equi-size skewness and volume size (no negative volumes) and all the volumes pass. Gambit gives me no clue as to what's wrong. Any ideas?
Thanks so much!
|Thread||Thread Starter||Forum||Replies||Last Post|
|Gambit geometry problem||cestrin||FLUENT||3||July 4, 2012 02:33|
|Problem with Mesh conversion Gambit msh Foam||Rachid BANNARI (Bannari)||OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ...||25||September 11, 2011 07:58|
|Gambit - meshing over airfoil wrapping (?) problem||JFDC||FLUENT||1||July 11, 2011 05:59|
|Gambit installation problem||Panos||FLUENT||4||March 5, 2009 23:44|
|Startup Problem in Gambit 2.2 with WindowXP||Win Win Maw||FLUENT||3||January 25, 2006 12:09|