CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   AGM-SOLVER (http://www.cfd-online.com/Forums/fluent/37345-agm-solver.html)

MANOJ July 22, 2005 03:51

AGM-SOLVER
 
I DOING THE COMBUSTION CHMBER PROBLEM BUT WHEN RUN IN THE TARBULENT WITH COMBUSTION THERE IS AGM-SOLVER AND SHOWING THAT TEMPERATURE LIMITS EXCEEDS 5.000E+3 AND ALSO THERE IS ENERGY LINE GOES SUDDENLY HIGH

zxaar July 22, 2005 08:05

Re: AGM-SOLVER
 
SO WHATS NEW IN THIS ????

xiong July 24, 2005 03:06

Re: AGM-SOLVER
 
i think you can change your limition of temperature higher than 5000

Venu Gopal July 24, 2005 15:05

Re: AGM-SOLVER
 
In fluent always there is a maximum limit for the temperature. So, your input values in such a way that the maximum values should lie with in that temperature. I think it is 5000K. So, change your input values

Venu

pUl| July 25, 2005 22:39

Re: AGM-SOLVER
 
lol

MANOJ August 1, 2005 04:49

Re: AGM-SOLVER
 
thank u my new problem is moving mesh i doing a tutorial in which a sheet of 1 mm thick and galavnizing in a 1m square box the sheet dip in one side of box at top left and come in right top of box. i want what is doing for moving the mesh and which type of boundry condition is given if any tutorial given in web-side then give address


All times are GMT -4. The time now is 02:14.