CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   Error on defining grid interfaces at FLUENT (http://www.cfd-online.com/Forums/fluent/37382-error-defining-grid-interfaces-fluent.html)

Ridwan July 26, 2005 12:42

Error on defining grid interfaces at FLUENT
 
Dear all,

I'm facing a little trouble. I've already specify the interfaces boundary types at Gambit. And then, when i defined "Grid Interfaces" at FLUENT, it can't works. There's an error at the fluent window, it was written like this "Error: Poly triangulate". What is the meaning of that? And how should i do to solve that error?

Thank you very much for your response.

Regards

Ridwan

dipak July 27, 2005 05:41

Re: Error on defining grid interfaces at FLUENT
 
the reason could be creating interface between a very large surface and a small surface...in that case, divide large surface into small surfaces and then use grid interface..

the reason may be surfaces are not co-planer...it happens partculary if you do in virtual operation in gambit...

Dipak



All times are GMT -4. The time now is 18:25.