Jet-in crossflow using Gambit
I am using Gambit and Fluent for the modeling and simulation (3-D) of a gaseous jet discharging from a circular pipe into a rectangular duct with crossflow. I would like to know, how to mesh such geometry (pipe normal to a rectangular duct) in Gambit.
Thanks a lot Maged |
Re: Jet-in crossflow using Gambit
Dear Friend:
You have better to use non-conformal mesh for this case. But if detect ralative dimension of duct and inlet pipe I can give you more exact offer. However, you can develop a structured hexahedral mesh, during an acceptable mesh constructing time, for this problem. Best Regards Mehdi Ghoddosy |
All times are GMT -4. The time now is 00:55. |