iam doing laminar non premixed combustion. i have done the cold flow simulation.can any one tell how to proceed to combustion modeling .

bye

I guess you set-up a complete model and included all specific requirements of the flamelet model including reaction. then,you turned them OFF and ran your simulation. this gave you a converged flow field. if this is what you did, then further things are: save the results of cold flow simulation in .dat file. turn ON all your reaction inputs and energy inputs. read the newly saved data file to start with the already known flow pattern and start the simulation. your source terms and energy equation will couple with the other equations.

Regards,

Swarup.

thank u