CFD Online Discussion Forums

CFD Online Discussion Forums (
-   FLUENT (
-   -   oil flow (

John August 22, 2005 21:33

oil flow
I would like to know more about the 'oil flow' option within the pathlines panel. Can this be used to simulated a very thin lubricant boundary layer on the inside of a pipe wall?

I cannot do this using the VOF model since the mesh size on the wall must be very very small. The lubricant layer needs to be only a few mm thick.

edi August 23, 2005 11:09

Re: oil flow
As far as I know that option has nothing to do with numerical modeling or solution techniques but it is just a post processing tip that displays the pathlines constrained to lie on a particular wall, if I'm not wrong...



All times are GMT -4. The time now is 11:45.