|September 7, 2005, 15:39||
Using Boundary Profiles (please help)
I have tried using the boundary profile panel to write the velocity values of a outlet of a geometry (case1). These velocity values are needed as inlet condition for anther case (case2). I read the profile file as "read file" for the second case.
The mesh on the outlet of case1 and mesh on the inlet of case2 matches, yet the values on x,y,z,k,epsilon dont match exactly. The manual says that zero order interpolation is performed. So if the coordinates match then the values should match.
Does anyone know why they dont?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Implementation of boundary conditions for FVM||Tom||Main CFD Forum||7||August 26, 2014 05:58|
|[CFD Post] Displaying boundary layer profiles||siw||CFX||0||July 4, 2011 12:15|
|mesh file for flow over a circular cylinder||Ardalan||Main CFD Forum||6||April 17, 2010 23:40|
|Boundary conditions?||Tom||Main CFD Forum||0||November 5, 2002 02:54|
|Boundary Conditions||Jan Ramboer||Main CFD Forum||11||August 16, 1999 08:59|