Home > Forums > Software User Forums > ANSYS > FLUENT

Electric arc furnace

Mark Forums Read

Reply

Search this Thread

September 10, 2005, 07:46	Electric arc furnace	#1
Homayoon Kanani Guest Posts: n/a	I am a student of M.Sc. of mechanical engineering. my thesis is about simulating the heat transfer in electric arc furnace and i should simulate the arc at first. i want to use FLUENT commercial code to do this but i don't know can i use the MHD module for modelling the arc or not. I would appreciate any suggestions regarding my thesis. thank you.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[blockMesh] meshing a cylinder	Nico A.	OpenFOAM Meshing & Mesh Conversion	6	June 19, 2017 14:12
Electric arc fault	chandu	CFX	8	August 24, 2012 07:44
[blockMesh] meshing a cylinder	Nico A.	OpenFOAM Meshing & Mesh Conversion	0	April 7, 2011 11:09
weird error during blockMesh	SePe	OpenFOAM	1	October 25, 2010 10:31
Electric arc furnace modeling..	Divyang Shah	Main CFD Forum	11	June 22, 1999 13:29

All times are GMT -4. The time now is 03:33.