Meshing divergent nozzle entry of a long pipe
 

I am trying to mesh a geomtery with structured mesh however i am unable to mesh it.

the geometry is a divergent nozzle entry into a long pipe. the divergent entrance also have a smaller pipe attached from above just 100mm before outlet for air entrance.

divergent nozzle (inlet D=150mm and outlet D= 254mm, length = 470mm) long pipe (dia=254mm, length=36000mm) smaller pipe (D= 50.8mm, length = 250mm)

any advice on how to mesh this geomtery will be highly appreciated.

Re: Meshing divergent nozzle entry of a long pipe
 

subdivide your domain